Heat Generation by Diode Laser (1064-nm) on Dental Implants. (An in vitro study) | ||
| Al-Rafidain Dental Journal | ||
| Article 9, Volume 21, Issue 2, September 2021, Pages 240-250 PDF (505.41 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.33899/rdenj.2021.129869.1099 | ||
| Author | ||
| Abdulhameed N Aldabagh* | ||
| Department of Oral and Maxillofacial Surgery | ||
| Abstract | ||
| Aims: The aim of this study was to assess temperature changes of dental implant body when using different wattage of diode laser (Fox laser 1064-nm) and set a proposed power setting that has no detrimental effect on adjacent bone. Materials and Methods: Seventy-five Titanium implants with healing screws were used in this study. Thermocouple technology was used to measure the temperature level generated in the dental implant body when being exposed to laser. The implants were fixed in an acrylic mandible model and then placed in a controlled water bath at 37 °C. Time to reach a temperature degree of 47 °C were recorded after each wattage as well as the dropping time of temperature to reach a degree of 37° C was recorded. Results: The decrease in time needed to reach 47 °C was directly related to an increase in wattage and as such the time is inversely related to wattage. All the recording time measures dropped to 37 °C with no significant differences. Conclusion: It can be concluded that using diode laser in at 6 wattages with pulsed wave settings produced high temperature with minimum time compared when using 2 wattage settings which needed more time to produce the same heat | ||
| Keywords | ||
| dental implant; Laser; Heat generation | ||
|
Statistics Article View: 290 PDF Download: 282 |
||