A STUDY ON THE INFLUENCE OF SHAPE OF BURNER ON THE MEASUREMENT OF THE LAMINAR BURNING VELOCITY | ||
| Journal of University of Anbar for Pure Science | ||
| Article 27, Volume 4, Issue 1, April 2010, Pages 88-95 PDF (435.91 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.37652/juaps.2010.15474 | ||
| Author | ||
| AHMED ALI NAJEEB | ||
| Anbar University - College of Engineering | ||
| Abstract | ||
| In this research, three burners are manufactured in different shapes (rectangular, square and circular). By optical Schielren system, velocity of laminar flame diffusion is measured for the three burners to the Iraqi Liguid Petrol Gas (LPG) and the beforehand mixed air at the laboratory condition (1 atm, 298o K) and for wide and equal range of equivalent ratios (Ф) in the three burners, and using the equivalent ratios as a comparison factor in this research. The experimental results were performed and the effect of the shape of burners on the laminar flame speed was studied. The results in this research gave a good agreement with the litretures.The agreement refers that there is a good accuracy in the method of calculation and measurement used in this research | ||
| References | ||
|
[1] Al-Khishali, K.J.M., “Turbulent Flame Propagation and Quenching”, Ph.D. Thesis, Dep.Of Mech., Eng., University of Leeds, U.K.(1984).
[2] Agrawal,D.D., “Combustion and Flame”,42:243-252(1981)
[3] Amos, M.D. and Willis J.B., Spectrochimica Acta, 22:1325 (1966).
[4] Andrews, G.E. and Bradly, D., “Combustion and Flame”, 18:133(1972-a).
[5] Andrews, G.E. and Bradly, D., “Combustion and Flame”, 19:175(1972-b).
[6] Andrews, G.E. and Bradly, D., “Combustion and Flame”, 20:77(1973).
[7] Barnard, J.A. and Bradley, J.N., “ Flame And Combustion”, 2 nd Ed Chapman
[8] Barthoolome ,E.Z., Electrochem.,53.191,(1949)
[9] Beer, J.M. and Chigger, N.A., “Combustion Aerodynamics”, Applied Science Publishers Ltd., (1972).
[10] Bonilla, R.H. and Maccallum, R.L., “Combustion and Flame”, 12:492 (1968).
[11] Chew, T.C., Britter, R.E. and Bray, K.N.C., “Combustion and Flame”, 75:165 (1982).
[12] Gibbs, G.J. and Calotte, H.F., J. Chemical and Engineering Data, 4:226 (1959)
[13] Gydon, A.G. and Wolfard, H.G., “Flames”, London,3 rd ed.(1970).
[14] Halpern ,C., J. of Research of Nationanal Burreau of Standars, 60:535 (1959)
[15] Hamid, M.N., “Fundamentals Turbulent Burning Related to Engines” Ph.D. Thesis, Dep. Of Mech. Eng., University of Leeds, U.K., (1986).
[16] Hani, M.E., “A study of Laminar Flame Propagation of (Propane, Iraqi L.P.G,Butane and Hydrogen)-Air Through Tube ” M. Sc. Thesis, Dep.Of Mech. Eng. University Of Technology, Iraq, (1998).
[17] Jarosiniski, J., “Combustion and Flame”, 56:337 (1984).
[18] Janich.G.Chemic ing Tech.,43,561 (1971`)(English Translation).
[19] John. N.Bradly, “Flame and Combustion Phenomena”, New York (1985).
[20] Kanury, A.M., “Introduction to Combustion Phenomena”, Gordon and Breach, Science Publishers, Inc., (1975)
[21] Kuo, K.K. “Principle of Combustion”, John Wiley and Sons, Inc.(1986).
[22] Law, C.K., Ishizuka, S.and Cho, P., “Combustion and Flame”, 28:89 (1982)
[23] Lewis, B. and Von-Elbe, G., “Combustion, Flames and Explosion of Gases” 2-nd ed., Academic Press, New York (1987).
[24] Madson, J.M. and Theby, E.A., Combustion.Sci.and Technol., 13:205 (1984).
[25] Mtghalchi, M.and Keck, J.C., “Combustion and Flame”, 38:143 (1980).
[26] Putnam, A.A., Ball D.A., And Levy, A., “Combustion and Flame”, 37:193 (1980).
[27] Raezer, S.D., and Olsen, H.L., “Combustion and Flame”, 6:223 (1962).
[28] Rallis, C.J., and Garforth, A.M., Prog Energy Combustion.Sci, 6:4 (1981).
[29] Reed, S.B.,. “Combustion and Flame”, 13:583 (1969).
[30] Roper,F.G. “Combustion and Flame”, 29,219-226 (1977).
[31] Sheu, W.J., Sohrad, S.H., and Sivashinnsky, G.I., “Combustion and Flame”, (1990).
[32] Smyth, K.C, Miller, J.H., Dorfman, R.C., Mallaard, W.G., and Sontoro, R.J., “Combustion and Flame”, 62:157 (1985).
[33] Sohrab, S.H. Law CK., “Combustion and Flame”, 62:243 (1985).
[34] Splading, D.B., “Combustion and Mass Transfer”, Pergamon Press Ltd., (1979).
[35] Stamulleanu, A., “Flame Combustion Processes in Industry” (1976).
[36] Toong, Tau –yi “Combustion Dynamics” , McGraw-Hill Inc., (1983)
[37] Turns, R.S., “An introduction to combustion”, McGraw-Hill Inc (2000).
[38] Williams, F.A., “Combustion Theory” ,New York Addision-Wesles-2 nd ed. (1985).
[39] Xiao, X., Cho,W.., and puri,I.K., “Combustion and Flame”, 120:31 (2000).
[40] Yamaoka, I. And Tsuji, H. Twentieth Symposium (International) on
Combustion, (1984).
[41] Zel’ Dovich, YA.B, Istratov, A.G., Kidin, N.i. and Librovich, V.B., Combust. Sci.Technol, 24:1(1980).
[42].أرکان [Arkan] فوزی سعید, تأثیر درجة الحرارة الابتدائیة على سرعة انتشار اللهب خلال أنبوب لخلائط (المیثان- البروبان- غاز البترول المسال العراقی) مع الهواء,رسالة ماجستیر مقدمة إلى قسم هندسة ألم کائن والمعدات/الجامعة التکنولوجیة,(2000). [43]. حسنین [Hassenein] عدنان البدر, تأثیر درجة الحرارة الابتدائیة على خصائص اللهب الطباقی فی المحرق الأنبوبی (لخلائط الوقود الغازی والهواء),رسالة ماجستیر مقدمة إلى قسم هندسة المکائن والمعدات /الجامعة التکنولوجیة ,(2001) [44].حیدر[Hiader] عبد ضهد ,دراسة سرعة انتنشار اللهب مسبق الخلط خلال انبوب باستعمال الخلایا الضوئیة رسالة ماجستیر مقدمة الى قسم هندسة المکائن والمعدات/الجامعة التکنولوجیة, (1997). [45].جاسم [Jassem] محمد عبد الکریم,استخدام تقنیة شلیرن فی دراسة انتشار اللهب الطباقی لمحرق ذی الشق,رسالة ماجستیر مقدمة الى قسم هندسة المکائن والمعدات/الجامعة التکنولوجیة (2002) [46].زیاد[Ziad] اسماعیل خلیل,سلوکیة احتراق الغازات المنتجة محلیا ,رسالة ماجستیر مقدمة الى قسم هندسة المکائن والمعدات /الجامعة التکنولوجیة ,(1982). [47] علی [Ali] رسول مهدی ,استخدام تقنیة شلیرن فی دراسة انتشار اللهب الطباقی لخلائط الوقود الغازی مع الهواء ,رسالة ماجستیر مقدمة الى قسم هندسة المکائن والمعدات/الجامعة التکنولوجیة, (2000). | ||
|
Statistics Article View: 207 PDF Download: 143 |
||