Phenol Adsorption from Aqueous Solutions onto Activated Carbon Produced from Iraqi Date-Stones. | ||
Journal of University of Anbar for Pure Science | ||
Article 14, Volume 6, Issue 3, December 2012, Pages 46-52 PDF (252.55 K) | ||
Document Type: Research Paper | ||
DOI: 10.37652/juaps.2012.78442 | ||
Author | ||
May F. Abdulrahman | ||
University of Anbar - College of Science | ||
Abstract | ||
This study is conducted to synthesize an activated carbon from date-stones using different concentration (20%,35%,50%) of phosphoric acid as activater. The carbon was soaked for 72 hours followed by carbonization at (500°C) for two hours. Specific surface area and pH were measured. The adsorption of phenol at different temperatures (283 K , 293 K , 313 K , 333 K ) from aqueous solutions onto activated carbon was investigated .The determination of phenol concentration at equilibrium solution was measured using U.V. spectrophotometer with an adsorbance wavelength of (211nm). The activated carbon exhibited high ability to adsorbe phenol from aqueous solutions. The maximum adsorption rates were 98.76% , 98.9% and 97.5% at an initial concentration of ( 240 mg/l ) of phenol and at 333K for activated carbon , (20% ,35% and 50%) , respectively. Adsorption isotherm was studied using Langmuir and Freundlich isotherm models .The characteristic parameters for each isotherm and related correlation coefficient have been determind .The results showed that the adsorption process of the synthetic activated carbon fits very well with the Freundlich isotherm model and in a lesser degree with Langmuir isotherm model . Thermodynamic parameters such as ∆G°, ∆H° and ∆S° have also been evaluated and it has been found that the sorption process was feasible, spontaneous and endothermic. | ||
Keywords | ||
phenol; adsorption; Activated Carbon; date; Stone | ||
References | ||
1- S. Rengaraj , M. SEUNY. Hyeon and R. Sivabalan (2002) . Waste Mangement , 22: 543-548.
2- Z. Aksu, and J. Yener (2001) . Waste Management, 21: 695-702.
3- Kh. A. Halouli, and N. M. Drawish (1995) . Sep.Sci.Technol, 30:3313-24.
4- S.H. Lin and M. J. Chery (2002) . Waste Management, 22 : 595-603.
5- Ni. Khalid , S. Ahmad and A. Toheed (2000) . Applied Radiation and Isotopes, 52: 30-38.
6- A. H. Mahvi , A. Maleki and Eslami (2004) . American Journal of Applied Sciences 4: 321-326.
7- G. M. Walker, L. Hansen ,J. A. Hauna and S.J. Allen (2003). Water Research , 37: 2081-2089.
8- W. Li. , K. Yany, J. Pehy, L. Zhang , S. Guo and H. Xia (2008). Industrial Crops and Products, 28: 190-198.
9- Moraitoponlos , Z. Ioannou and J. Simitzis (2009) . World Academy of Science, Engineering and Technology, 58: 218-222.
10- H. March and F. R. Reinoso (2006). Elsevier Science and Technology Books.
11- M. Yusra Alobaidy (2010). Baghdad Science Journal, 7:766-772.
12- P. Senthil Kumar, K. Ramakrishnan, S. Dinesh Kirupha and S. Sivanesan, (2010) . Brazilian Journal of Chemical Engineering. 27: 347-355.
13- B. Amy Cerato and J. Alan Lutenegger and (2002). Geotechnical Testing Journal, 25:253.
14- Y. Kartika , N. Indraswati , S. Ismadji and D. Parakas (2008). Chemical Engineering, Journal 140:32-42.
15- R. U. Perez , F. C. Marin , D. F. Jimenez and C. M. Castilla (2006) . Microporous and Mesoporous Matirials , 92:64-70.
16- A. M. Youssef , N. R. E. Radwan , I. Abdel-Gawad and G. A. A. Singer (2005) . Colloids and Surface A. 252:143-151.
17- M. Sekirifa and M. Hadj –Mahammed (2005) . Sci. Techno , 23:55
18- I. Ismail Al-Kateeb and A. Ali Al-Mehemdy (2011) . Chem. Eng. 5:715-719. | ||
Statistics Article View: 176 PDF Download: 139 |