Evaluate the granite waste efficiency in the construction using statistical indicators | ||
| Anbar Journal of Engineering Sciences | ||
| Article 7, Volume 14, Issue 1, May 2023, Pages 66-72 PDF (1.57 M) | ||
| Document Type: Research Paper | ||
| DOI: 10.37649/aengs.2023.137755.1037 | ||
| Authors | ||
| Mohammad Rostam Tahir* 1; Mohammed Jameel Yaseen2 | ||
| 1University of salahaddin, Erbil, Iraq | ||
| 2Kurdistan Board of Investment, Erbil, Iraq | ||
| Abstract | ||
| Due to the expansion of industrial operations globally in recent years, waste output has risen. So these wastes must be reduced by recycling and reusing to achieve environmentally friendly buildings and find various alternative materials in critical cases. The statistical indicators are used as practical study including Multiple linear regression (MLR) and artificial neural network (ANN) models. The study's goals were to assess the effectiveness of granite waste (GW) as a replacement for cement, sand, plastic, and binder in specific building applications and the relationships between MLR and ANN approaches. Results show the efficiency of adding granite waste to some construction stages and replacing it with cement in the mixture and examining its strength, it gave excellent results in addition to good results for its use as a binder in cement mortar, while the results were weak when used as a substitute for sand and plastic in insulator because it's classified as fine sand, Therefore, it cannot be used as a substitute for sand in the construction. The statistical models give an effective indicator to use GW as an alternative material ( binder and cement) based on the coefficient of correlation (R2) for the two models MLR and ANN equal to 83.4 % and 80 % respectively. | ||
| Keywords | ||
| Granite waste; Binder; Recycling; ANN; Regression | ||
| References | ||
|
[1] A. Karmegam, A. Kalidass, and D. Ulaganathan, “Utilization of granite sawing waste in self compacting concrete,” Građevinar, vol. 66, no. 11., pp. 997–1006, Dec. 2014.
[2] S. C. H and D. Venkatesh, “Optimization of Granite Powder used as Partial Replacement to Cement in the Design of Ready Mix Concrete of M20 Grade using IS10262:2009,” Int. J. Eng. Res. Technol., vol. 4, no. 1, Jan. 2015, doi: 10.17577/IJERTV4IS010142.
[3] Z. Al-Adeeb, “Feasibility study of recycling waste from marble and stone factories in the building materials industry,” Damascus university, 2015.
[4] M. Fakhri and F. Saberi. K, “The effect of waste rubber particles and silica fume on the mechanical properties of Roller Compacted Concrete Pavement,” J. Clean. Prod., vol. 129, pp. 521–530, Aug. 2016, doi: 10.1016/j.jclepro.2016.04.017.
[5] A. Albassrih and Z. K. Abbas, “Properties of Roller-Compacted Concrete Pavement Containing Different Waste Material Fillers,” J. Eng., vol. 28, no. 9, Art. no. 9, Sep. 2022, doi: 10.31026/j.eng.2022.09.06.
[6] Z. Z. Woźniak, A. Chajec, and Ł. Sadowski, “Effect of the Partial Replacement of Cement with Waste Granite Powder on the Properties of Fresh and Hardened Mortars for Masonry Applications,” Materials, vol. 15, no. 24, Art. no. 24, Jan. 2022, doi: 10.3390/ma15249066.
[7] M. S. Savadkoohi and M. Reisi, “Environmental protection based sustainable development by utilization of granite waste in Reactive Powder Concrete,” J. Clean. Prod., vol. 266, p. 121973, Sep. 2020, doi: 10.1016/j.jclepro.2020.121973.
[8] M. M. S. Lopes et al., “Optimization of performance of sustainable paints using granite waste through the variation of particle size and pH,” J. Clean. Prod., vol. 326, p. 129418, Dec. 2021, doi: 10.1016/j.jclepro.2021.129418.
[9] D. S. Chouhan, Y. Agrawal, and T. G. and R. K. Sharma, “Utilization of Granite Slurry Waste in Concrete: A Review,” Indian J. Sci. Technol., vol. 10, no. 6, pp. 1–9, Feb. 2017, doi: 10.17485/ijst/2017/v10i6/88279.
[10] J. A. J., F. F. Gh., and A.-B. N. M., “Effect of marble powder on the properties of self-compacting concrete,” in 29-31, 2019.
[11] G. Pirmohammadi and M. Mast, “Comparison of Artificial Neural Network and SPSS Model in Predicting Customers Churn of Iran’s Insurance Industry,” Int. J. Comput. Appl., vol. 176, no. 32, pp. 14–21, Jun. 2020, doi: 10.5120/ijca2020920345.
[12] A. M. Salal and B. H. Khudair, “Influent Flow Rate Effect On Sewage Pump Station Performance Based On Organic And Sediment Loading,” J. Eng., vol. 25, no. 9, Art. no. 9, Aug. 2019, doi: 10.31026/j.eng.2019.09.1.
[13] M. Kıranşan, A. Khataee, S. Karaca, and M. Sheydaei, “Artificial neural network modeling of photocatalytic removal of a disperse dye using synthesized of ZnO nanoparticles on montmorillonite,” Spectrochim. Acta. A. Mol. Biomol. Spectrosc., vol. 140C, pp. 465–473, Jan. 2015, doi: 10.1016/j.saa.2014.12.100.
[14] L. K. Abidoye, F. M. Mahdi, M. O. Idris, O. O. Alabi, and A. A. Wahab, “ANN-derived equation and ITS application in the prediction of dielectric properties of pure and impure CO2,” J. Clean. Prod., vol. 175, pp. 123–132, Feb. 2018, doi: 10.1016/j.jclepro.2017.12.013.
[15] F. Farooq, W. Ahmed, A. Akbar, F. Aslam, and R. Alyousef, “Predictive modeling for sustainable high-performance concrete from industrial wastes: A comparison and optimization of models using ensemble learners,” J. Clean. Prod., vol. 292, p. 126032, Apr. 2021, doi: 10.1016/j.jclepro.2021.126032. | ||
|
Statistics Article View: 35 PDF Download: 25 |
||