Dynamic Simulation and Optimization of Flat Plate Solar Collector Parameters Using the MATLAB Program for Erbil-Iraq Climate Condition | ||
| Al-Rafidain Engineering Journal (AREJ) | ||
| Article 13, Volume 27, Issue 2, September 2022, Pages 127-139 PDF (1.97 M) | ||
| Document Type: Research Paper | ||
| DOI: 10.33899/rengj.2022.133419.1167 | ||
| Authors | ||
| Kamaran Fatah Rashid* ; Idres Azzat Hamakhan; Chalang Hamarasheed Mohammed | ||
| Mechanical and Mechatronics Department, Collage of Engineering, University of Salahaddin, Erbil, Iraq | ||
| Abstract | ||
| This research aims to investigate the performance of solar water collector by varying: mass flow rate, inclination angle, total solar radiation, pipe size, and number of glass covers. The test rig was established to collect the data for the whole months of September and October and use it as a focal point for analysis of the solar water heating system's performance. The dynamic behavior was simulated and optimized with MATLAB software for the practical data to investigate the performance of the flat plate solar collector. The novelty in this study is the first time the authors use the whole practical data instead of average data to approximate the theoretical dynamic investigation of the flat plate solar collector. The achievements are as follows: the collector'sefficiency was increased from 62.17% to 71.26% when the collector pipe spacing was reduced from 186 mm to 86 mm; the increase in efficiency was approximately 2% as the collector pipeline diameter increased from 1 mm to 50 mm; the optimum efficiency was achieved with triple glazing and was about 0.83%; the mass flow rate increases from 1 to 5 liters per minute, so it improves the efficiency of the system from 64% to 83%. Moreover, the best tilt angle for the flat plate solar collector was 30°. Also, the heat loss coefficient was raised by around 50% when wind speed was increased from 1 m/s to 5 m/s. Thus, the use of dynamic investigation with actual data will assist the researchers in improving the performance of the solar water flat plate collector. | ||
| Keywords | ||
| Dynamic simulation; Solar energy; Collector efficiency; Performance analysis | ||
| References | ||
|
[1] C. Kim, "A review of the deployment programs, impact, and barriers of renewable energy policies in Korea," Renewable and Sustainable Energy Reviews, vol. 144, p. 110870, 2021.
[2] S. A. Kalogirou, "Solar thermal collectors and applications," Progress in energy and combustion science, vol. 30, no. 3, pp. 231-295, 2004, doi: http://dx.doi.org/10.1016/j.pecs.2004.02.001.
[3] K. K. F. Rashid, I. I. A. Hamakhan, and C. C. H. Mohammed, "Tilt Angle Optimization and Investigation of the Behavior of a Flat Plate Solar Collector Using MATLAB for Kurdistan Climate Conditions-Iraq," International Journal of Heat and Technology, vol. 40, no. 2, pp. 583-591, 2022, doi: http://dx.doi.org/10.18280/ijht.400227.
[4] S. Mekhilef, R. Saidur, and A. Safari, "A review on solar energy use in industries," Renewable and sustainable energy reviews, vol. 15, no. 4, pp. 1777-1790, 2011, doi: http://dx.doi.org/10.1016/j.rser.2010.12.018.
[5] A. Sözen, T. Menlik, and S. Ünvar, "Determination of efficiency of flat-plate solar collectors using neural network approach," Expert Systems with Applications, vol. 35, no. 4, pp. 1533-1539, 2008, doi: http://dx.doi.org/10.1016/j.eswa.2007.08.080.
[6] H. Dagdougui, A. Ouammi, M. Robba, and R. Sacile, "Thermal analysis and performance optimization of a solar water heater flat plate collector: application to Tétouan (Morocco)," Renewable and Sustainable Energy Reviews, vol. 15, no. 1, pp. 630-638, 2011.
[7] A. M. Do Ango, M. Médale, and C. Abid, "Optimization of the design of a polymer flat plate solar collector," Solar Energy, vol. 87, pp. 64-75, 2013, doi: http://dx.doi.org/10.1016/j.solener.2012.10.006.
[8] P. Cooper, "The effect of inclination on the heat loss from flat-plate solar collectors," Solar Energy, vol. 27, no. 5, pp. 413-420, 1981, doi: http://dx.doi.org/10.1016/0038-092X(81)90006-2.
[9] S. Agbo and E. Okoroigwe, "Analysis ofThermal Losses in the Flat-Plate Collector of a Thermosyphon Solar Water Heater," Research journal of Physics, vol. 1, no. 1, pp. 35-41, 2007.
[10] J. Ma, W. Sun, J. Ji, Y. Zhang, A. Zhang, and W. Fan, "Experimental and theoretical study of the efficiency of a dual-function solar collector," Applied Thermal Engineering, vol. 31, no. 10, pp. 1751-1756, 2011.
[11] K. Ogata, Discrete-time control systems. Prentice-Hall, Inc., 1995.
[12] E. Amer, J. Nayak, and G. Sharma, "Transient method for testing flat-plate solar collectors," Energy Conversion and Management, vol. 39, no. 7, pp. 549-558, 1998, doi: http://dx.doi.org/10.1016/S0196-8904(97)10014-0.
[13] W. Kong et al., "An improved dynamic test method for solar collectors," Solar Energy, vol. 86, no. 6, pp. 1838-1848, 2012.
[14] R. Tang, Y. Cheng, M. Wu, Z. Li, and Y. Yu, "Experimental and modeling studies on thermosiphon domestic solar water heaters with flat-plate collectors at clear nights," Energy Conversion and Management, vol. 51, no. 12, pp. 2548-2556, 2010, doi: http://dx.doi.org/10.1016/j.enconman.2010.04.015.
[15] B. O. Bolaji, "Exergetic analysis of solar drying systems," 2011, doi: http://dx.doi.org/10.4236/nr.2011.22012.
[16] B. O. Bolaji, "Flow design and collector performance of a natural circulation solar water heater," 2006.
[17] J. A. Duffie, W. A. Beckman, and N. Blair, Solar engineering of thermal processes, photovoltaics and wind. John Wiley & Sons, 2020.
[18] I. Ajunwa, D. Yawas, D. Kulla, and I. U. Ibrahim, "Thermal Performance Optimization of Flat Plate Solar Collector using MATLAB," Jurnal Mekanikal, 2020.
[19] S. Abubakar, S. Umaru, M. Kaisan, U. Umar, B. Ashok, and K. Nanthagopal, "Development and performance comparison of mixed-mode solar crop dryers with and without thermal storage," Renewable energy, vol. 128, pp. 285-298, 2018, doi: http://dx.doi.org/10.1016/j.renene.2018.05.049.
[20] B. O. Bolaji and A. P. Olalusi, "Performance evaluation of a mixed-mode solar dryer," 2008.
[21] D. Reindl, W. Beckman, and J. Duffie, "Evaluation of hourly tilted surface radiation models," Solar energy, vol. 45, no. 1, pp. 9-17, 1990, doi: http://dx.doi.org/10.1016/0038-092X(90)90061-G.
[22] Y.-D. Kim, K. Thu, H. K. Bhatia, C. S. Bhatia, and K. C. Ng, "Thermal analysis and performance optimization of a solar hot water plant with economic evaluation," Solar energy, vol. 86, no. 5, pp. 1378-1395, 2012, doi: https://doi.org/10.1016/j.solener.2012.01.030.
| ||
|
Statistics Article View: 442 PDF Download: 491 |
||