Effect of Inclination of Rectangular Reinforced Concrete Short Columns on the Confinement | ||
| Engineering and Technology Journal | ||
| Article 11, Volume 39, Issue 12, December 2021, Pages 1821-1827 PDF (760.05 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.30684/etj.v39i12.437 | ||
| Authors | ||
| Eyad K. Sayhood* ; Bassman R. Muhammed; Ahmed A. Hatem | ||
| Civil Engineering Department,University of Technology-Iraq, Alsina’a street, P.O BOX 10066 Baghdad, Iraq. | ||
| Abstract | ||
| The main objective of this paper is to study the confinement of the rectangular reinforced concrete short inclined columns. This paper was based on theoretical analysis using the MATLAB program according to Universal Codes, and variables that were carefully selected to be the most influential factor. The angle of the inclination (α) was taken as a major variable in the paper, in addition other variables which in turn affect directly on the behavior of inclined columns such as the percentage of reinforcing steel in the concrete section of the column (ρ), the compressive strength of the concrete (fʹc), yield strength of steel bars (fy) and effective depth ratio (γ). The results show that best ratio of reinforcing steel that improves the value of the confinement ranges from 0.4 - 0.6 which leads to an increase in the confinement of (60 – 100) %, and these rates increase with increasing α, and the increase in fʹc leads to a significant increase in the confinement, especially when HSC is used..On the other hand, decreasing fy leads to increase in confinement, and the value of the γ had a considerable effect on the confinement that was decreased by about 11% when γ equals 0.9, compared with the corresponding γ equals 0.6. | ||
Highlights | ||
| ||
| Keywords | ||
| Confinement; Angle of the inclination; compressive strength; Effective depth ratio; Yield strength of steel bars | ||
| References | ||
|
[1] N. Subramanian Design of confinement reinforcement for RC columns. The Indian Concrete Journal, 6 (2011) 1-9. [2] F. Richart, A. Brandtzaeg and R. Brow. A study of the failure of concrete under combined compressive stresses. Engineering Experiment Station Bulletin No. 185, University of Illinois, Urbana, (1928). [3] S. Popovics. A numerical approach to the complete stress-strain curves for concrete, 5 (1973) 583–599. [4] A. Elwi and D. Murray. A 3D Hypoelastic Concrete Constitutive Relationship. J. Eng. 105 (1979) 623-641 [5] D. Kent and R. Park, "Flexural Members with Confined Concrete," Journal, Structural Division, ASCE, 97 (1971) 1969-1990. [6] S. Sheikh and S. Uzumeri Strength and ductility of tied concrete columns. (1980) 1079–112. [7] J. Mander, M. Priestley and R. Park. Observed stress-strain behavior of confined concrete, ASCE Journal of Structural Engineering, 114 (1988)1827-1849. [8] S. Sheikh and S. Khoury. Performance-Based Approach for the Design of Confining Steel in Tied Columns, ACI Structural Journal, 94 (1997) 421-431. [9] ACI Committee 318, Building Code Requirements for Structural Concrete (ACI 318M-14 (6.6.4.3)) and Commentary, American Concrete Institute, Farmington Hills, MI 48331, USA, (1995). [10] O. Bayrak and S. Sheikh, Confinement Reinforcement Design Considerations for Ductile HSC Columns, Journal of Structural Engineering, ASCE, 124 (1998) 999-1010. [11] P. Paultre and F. Légeron, Confinement Reinforcement Design for Reinforced Concrete Columns, Journal of Structural Engineering, 134 (2008) 738-742. [12] S. Eyad, M. Bassman and H. Ahmed, Behavior of Reinforced Concrete Inclined Rectangular Short Columns, Master thesis, University of Technology, civil engineering department, (2019) 42-45. [13] IS 13920:1993, Indian standards code of practice for Ductile detailing of reinforced concrete structures subjected to seismic forces, Bureau of Indian Standards, New Delhi, India. [14] ACI Committee 318, Building Code Requirements for Structural Concrete (ACI 318M-14 (6.6.4.3)) and Commentary, American Concrete Institute, Farmington Hills, MI 48331, USA, (2014). [15] NZS 3101:2006, Concrete Structures Standard, Part 1- The Design of Concrete Structures and Part 2 Commentary on the Design of Concrete Structures, Standards Association of New Zealand, Wellington, New Zealand, (2006) 646. [16] CSA A23. 3-04, Design of Concrete Structures, Canadian Standards Association, Mississauga, ON, Canada, (2004) 258. | ||
|
Statistics Article View: 294 PDF Download: 458 |
||