The Solubility of Phosphogypsum and Recovery of Heavy and Radioactive Elements | ||
| Engineering and Technology Journal | ||
| Article 7, Volume 38, 10A, October 2020, Pages 1470-1480 PDF (1.23 M) | ||
| Document Type: Research Paper | ||
| DOI: 10.30684/etj.v38i10A.907 | ||
| Authors | ||
| Waleed T. Rashid* 1; Israa A. Alkadir1; Moayyed G. Jalhom2 | ||
| 1Production and Metallurgy Engineering Department, University of Technology, Baghdad, Iraq. | ||
| 2Moayyed G.Jalhom, Ministry of Industry and Minerals, Baghdad, Iraq, | ||
| Abstract | ||
| The essential purpose of this paper is to illustrate and inspect the leaching characteristics of Iraqi Phosphogypsum (PG). The paper presents the results of the dissolution characteristics of heavy and radioactive elements from PG, which is a by-product result from the industry of phosphate fertilizers. Leachability of heavy and radioactive elements in deionized water that has been inspected under various states of leaching, including solid/liquid ratio (10, 20 and 50 /1g/L) and temperatures (25, 45 and 85 °C), with constant other parameters such as string speed (300 rpm) and contact time (60 minutes). For the most analysis elements, the progressive release of the metals, in addition to the major elements reflects high mobility. The mobility of trace metals in PG has been generally classified into three main degrees: (1) high mobility elements such as Pb, Zn, Mn, and Cr; (2) moderate mobility elements such as Sr, V, Ba,Y,Hg, K and Ni; and (3)l ow mobility elements like Ca,Cu,Fe, and Ag. The maximum concentrations of the most of the metals were attained from a leaching state of 10/1g/L. Regarding temperature, the experimental results revealed that the PG solubility to leaching out elements increases noticeably as the applied temperature ranges from 25 to 45 °C; after this degree, the leaching efficiency decreases. Chloride had a positive and negative effect on the solubility of phosphorus. Calcium chloride had an adverse effect on solubility and observed reduced solubility with increased chloride. While the positive effect of sodium and magnesium chloride was observed, the solubility ratio increased with the increase of chlorides. However, the effect of magnesium chloride was higher compared to the sodium chloride one | ||
| Keywords | ||
| Phosphogypsum; leaching; heavy elements; radioactive elements | ||
| References | ||
|
[1] F.R. Gennari, I. Garcia, N. H. Medina, M. A. G. Silveira“Phosphogypsum Analysis: Total Content And Extractable Element Concentration” International Nuclear Atlantic Conference, 24-28, 2011. [2] M., Canut “Viability study for the substitution of gypsum by phosphogysum as a building material ”Belo Horizonte, Universidade Federal de Minas Gerais, 2006. [3] C. A. Gregory, D. Saylak, W. B. Ledbetter, “The use of by-product phosphogypsum for road bases and subbases”, Transportation Research Record, 998, pp 47-52, 1984. [4] Florida Institute of Phosphate Research – FIRP, “The economic benefit of phosphogysum use in agriculture in the Southeastern United States”. Bartow, FIPR Publication, 01, pp124-119, 1996. [5] P. R Ernani, M. S. Ribeiro, C. Bayer, “Chemical modifications in acid soils caused by addition of gypsum or limestone,” Sci. Agric., 58: pp 825-831, 2001. [6] P. A. Bellingieri, E.G. Bertin, L. Z. Mays, “Effects of the application of sewage, slags and limestone in the chemical properties of a soil cultivated with corn,” Scientifica, 31 pp 81-89, 2003. [7] J. Keith Syers, “Progress in the development of decimation of phosphorus fertilizers. In: Conference Fertilizer in Focus, “Fertilizer Industry Federation of Australia, Inc., pp. 28–29. 2001. [8] JICA (Japan International Cooperation Agency), “Preliminary feasibility study report on mining and industrial sector in Mid-Western,” Iraq, 2010. [9] M. Al-Hwaiti, K. Ibrahim, M. Harrara, “Removal of heavy metals from waste phosphogypsum materials using polyethylene glycol and polyvinyl alcohol polymers,” Arabian Journal of Chemistry, 2015. [10] M.S. Al-Masri, Y. Amin, S. Ibrahim, F. Al-Bich, “Distribution of some trace metals in Syrian phosphogypsum,” Applied Geochemistry, Vol. 19, pp. 747–753, 2004. [11] N M. Alkheder, Y.J., Kher A. Alkhateb, and A. Kodlaa, “Treatment of Syrian phosphogypsum using acids and bases,” Chemistry and Materials Research, Vol. 8 No.9, 2016. [12] A. Smith and B. Wrench, “Aspects of environmental control of phosphogypsum waste disposal. ” Proc., Reg. Conf. for Africa on Soil Mechanics and Foundation Engineering, 487-490, 1984. [13] M. Abd El-Mottaleb, M. F. Cheira, A. H. Gamal , A. S. Ahmed, “ Leaching of Rare Earth Elements from Egyptian Western Desert Phosphate Rocks using HCl,” Chemistry of Advanced Materials Vol.1,No.1 ,pp33-40,2016. [14] K. Grabas, A. Pawełczy, W. Stre, E. Szełe, S. Stre, “ Study on the Properties of Waste Apatite Phosphogypsum as a Raw Material of Prospective Applications,” Waste and Biomass Valorization,2018. [15] A. T. Hoang, H. M. Ang, A. L. Rohl, “Effects of temperature on the scaling of calcium sulphate in pipes,” Powder Technology, 179, pp 31–37, 2007. [16] E. Bock, “On the solubility of anhydrous calcium sulphate and of gypsum in concentrated solutions of sodium chloride at 25 °C, 30 °C, 40 °C, and 50 °C, ” Canadian Journal of Chemistry. Vol. 39, No.9, pp. 1746–1751, 1961. [17] G. Azimi, V.G. Papangelakis, J.E. Dutrizac, “Development of an MSE-based chemical model for the solubility of calcium sulfate in mixed chloride–sulfate solutions,” Fluid Phase Equilib., 266, pp172-186, 2008. [18] G. Azimi, V.G Papangelakis., “Mechanism and kinetics of gypsum-anhydrite transformation in aqueous electrolyte solutions,” Hydrometallurgy 108, pp 122-129,2011. [19] W. L. Marshall, R. Slusher, “Thermodynamics of calcium sulfate dehydrate in aqueous sodium chloride solutions,” 0−110°. J. Phys. Chem., 70, pp. 4015−4027, 1966. [20] J. Sun, L. Wangand, Y.Guomin, “ Effects of Na, Ca, Mg, and Al Chloride Salts on Dissolution and Phase Stability of Calcium Sulfate Dihydrate in Aqueous Solutions at 278.15 K to 308.15 K,” Journal of Chemical & Engineering Data, 2015 | ||
|
Statistics Article View: 279 PDF Download: 212 |
||