Removal of Iron From Produced Water Using Silica Adsorbent Material | ||
| Engineering and Technology Journal | ||
| Article 7, Volume 38, 8A, August 2020, Pages 1154-1159 PDF (713.95 K) | ||
| Document Type: Research Paper | ||
| DOI: 10.30684/etj.v38i8A.1125 | ||
| Authors | ||
| Zamen K. Mekhelf* 1; Akeel D. Subhi2; Ramzy S. Hamied3 | ||
| 1Production Engineering and Metallurgy Department, University of Technology-Iraq, | ||
| 2Production Engineering and Metallurgy Department, University of Technology-Iraq. | ||
| 3Petroleum Technology Department, University of Technology-Iraq, | ||
| Abstract | ||
| The removal of Iron from produced water using adsorbent materials is taking a space of attention from the perspective of researchers. In this work, the characterization of chemically modified silica used as Iron ions adsorbent using Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), laser granularity instrument was performed. The point of zero charge (PZC) of modified silica was determined using titration method. Different parameters were used to better approach Iron removal. These parameters are 0.2 and 0.4 mg/l modified silica adsorbent dose, 30-180 min adsorption time and pH values of 4-10. The results showed that modified silica exhibited higher removal efficiency of Iron due to its surface characteristics. The results also showed that at 60 min adsorption time and pH 7, the maximum Iron removal efficiency with 99.99% and 99.98% was obtained using modified silica dose of 0.4 mg/l and 0.2 mg/l, respectively. | ||
| Keywords | ||
| Iron removal; Produced Water; silica adsorbent; Chemical method | ||
| References | ||
|
[1] S. R. Utjok, W. Setyo, K. Khoiruddin, W.K. Anita, I.G. Wenten, “Oilfield produced water reuse and reinjection with membrane”, MATEC Web of Conferences, Indonesia, pp. 1-10, 2018. [2] Z. Karm. R. S. Hameed, A. D. Subhi, “Characterization of synthesized γ-Al2O3 powder as adsorbent material for removal of copper from produced water”, Journal of Mechanics of Continua and Mathematical Sciences, Vol. 14, No. 6, pp. 403-412, 2019. [3] A. A. Al-Haleem, A. H. Razaq, “Oilfield produced water management: treatment: reuse and disposal”, Baghdad Science Journal, Vol. 9, No. 1, pp. 1-9, 2012. [4] E. E. El Sayed, “Natural diatomite as an effective adsorbent for heavy metals in water and wastewater treatment (a batch study)”, Water Science, Vol.32, No. 1, pp. 32-43, 2018. [5] A. J. Ena'am, A. K. Sa'ad, “Geochemical impacts of the physical parameters and heavy metals risk of the drinking bottled water produced and marketed in Baghdad city, Iraq”, Journal of Natural Sciences Research, Vol. 6, No. 14, pp. 1-8, 2016. [6] N. Masoud, J. Iman, “Produced water from oil-gas plants: a short review on challenges and opportunities”, Periodica Polytechnica Chemical Engineering, Vol. 61, No. 2, pp. 73-81, 2017. [7] A. Elham, A. D. Richard, E. N. Ashly, Y. Kyoungkeun, “Magnetic adsorbents for the recovery of precious metals from leach solutions and wastewater”, Metals, Vol. 7, No. 12, pp. 1-32, 2017. [8] O. A. Elhefnawy, A. A. Elabd, “Natural silica sand modified by calcium oxide as a new adsorbent for uranyl ions removal from aqueous solutions”, Radiochimica Acta, Vol.105, No. 10, pp. 821–830, 2017. [9] M. Valentukevičienė, “Experimental research on removal of Iron and ammonium ions from groundwater by natural silica sand”, Geologija., Vol. 50, No. 3, pp. 201–205, 2008. [10] A. A. El-Bayaa, N. A. Badawy, A. M. Gamal, I. H. Zidan, A. R. Mowafy, “Purification of wet process phosphoric acid by decreasing Iron and uranium using white silica sand”, Journal of Hazardous Materials, Vol. 190, No.1, pp. 324–329, 2011. [11] S. Malekmohammadi, A. Mirbagheri, M. Ehteshami, “Comparison of silica, activated carbon, and zeolite adsorbents in the removal of ammonium, Iron, cod, turbidity and phosphate pollutants, and investigating the effect of discharge on the removal of pollutants”, International Journal of Humanities and Cultural Studies, Vol. 3, No.2, pp. 667–679, 2016. [12] D. Thakuria, B. Godboley, “Contamination and removal of Iron and fluoride from groundwater by adsorption and filtration: a review”, International Journal of Science Technology & Engineering, Vol. 2, No. 7, pp. 80–85, 2016. [13] M. S. Alvarez, A. S. Uribe, M. M Mirnezami, J. Finch, “The point of zero charge of phyllosilicate minerals using the mular–roberts titration technique”, Minerals Engineering, Vol. 23, No. 5, pp. 383–389, 2010. [14] S. Rita, R. Eti, K. Tetty, “Amino propyltrimethoxysilane (APTMS) modified nano silica as heavy metal Iron (Fe) adsorbents in peat water,” International Conference on Science and Applied Science (ICSAS), AIP Conf. Proc., pp. 1-7, USA, 2014. [15] M. Danaei, M. Dehghankhold, S. Ataei, F. H. Davarani, R. Javanmard, A. Dokhani, S. Khorasani, M. R. Mozafari, “Impact of particle size and polydispersity index on the clinical applications of lipidic nanocarrier systems”, Pharmaceutics, Vol. 14, No. 6, pp. 1–17, 2018. [16] V. Orodu, S. Olisedeme, RC. Okpu, “Removal of heavy metals from aqueous solutions using snail shell powder as available adsorbent”, International Journal of Science and Technology, Vol. 3, No. 7, pp. 422–428, 2014. | ||
|
Statistics Article View: 277 PDF Download: 165 |
||