Habeeb Faidh-Allah, M., Abdulkareem Ismail, S. (2018). Optimization of Cutting Parameters on Delamination of Drilling Glass-Polyester Composites. Alustath, 24(2), 34-45.
Majid Habeeb Faidh-Allah; Sanad Abdulkareem Ismail. "Optimization of Cutting Parameters on Delamination of Drilling Glass-Polyester Composites". Alustath, 24, 2, 2018, 34-45.
Habeeb Faidh-Allah, M., Abdulkareem Ismail, S. (2018). 'Optimization of Cutting Parameters on Delamination of Drilling Glass-Polyester Composites', Alustath, 24(2), pp. 34-45.
Habeeb Faidh-Allah, M., Abdulkareem Ismail, S. Optimization of Cutting Parameters on Delamination of Drilling Glass-Polyester Composites. Alustath, 2018; 24(2): 34-45.

Optimization of Cutting Parameters on Delamination of Drilling Glass-Polyester Composites

Journal of Engineering
Article 1, Volume 24, Issue 2, February 2018, Pages 34-45
Authors
Majid Habeeb Faidh-Allah; Sanad Abdulkareem Ismail
Abstract
This paper attempted to study the effect of cutting parameters (spindle speed and feed rate) on delamination phenomena during the drilling glass-polyester composites. Drilling process was done by CNC machine with 10 mm diameter of high-speed steel (HSS) drill bit. Taguchi technique with L16 orthogonal layout was used to analyze the effective parameters on delamination factor. The optimal experiment was no. 13 with spindle speed 1273 rpm and feed 0.05 mm/rev with minimum delamination factor 1.28.
Keywords
Composite Materials; drilling; delamination; Taguchi method
Statistics
Article View: 60
PDF Download: 41


Journal Management System. Powered by ejournalplus.com