1.

Characteristics of Zinc Oxide Film Prepared by Chemical Spray Deposition as a Gas Sensor

Volume 9, Issue 14, April 2011, Pages 25-30
Ahmed A.Ali; Shatha S.Botress; Moroog A. Abood; Ashuak A. Jabor; Rasheed H. Jabaar; Naseer M.Hadi; Abdul-Hussain K.Iltaif; Mohammed K.Khalaf
2.

Combined therapy for pain of different origin : (Study of 100 cases)

Volume 19, Issue 1, June 2013, Pages 76-80
AbdulbkiAlhayani .M aryam.m; Kh. Bakkosh
3.

EFFECT THE RADIAL STRAIN ON THE PERFORMANCE EVALUATION OF AN ELECTRO OPTIC MODULATOR

Volume 14, Issue 3, September 2014, Pages 305-316
Sadeq Adnan Hbeeb
4.

Enhancement Solution to Improve Remediation of Soil Contaminated with Lead by Electrical Field

Volume 21, Issue 11, November 2015, Pages 111-129
Ibtihal Tarik Rashid; Ayad Abd Al-hamza Faisal
5.

Estimation of Optimum Conditions for Cadmium Removal from Contaminated Soil using Electro-Kinetic Remediation

Volume 20, Issue 5, December 2017, Pages 1124-1129
Ahmed Alaa Hussein
6.

Experimental Investigation of the Electro Co-deposition of (Zinc-Nickel) Alloy

Volume 24, Issue 2, February 2018, Pages 46-61
Ekhlas Abdulrahman Salman
7.

High Order Sliding Mode Observer-Based Output Feedback Controller Design For Electro-Hydraulic System

Volume 12, Issue 4, December 2016, Pages 1-11
Shibly Ahmed AL-Samarraie; Mustafa H. Mishary
8.

Modeling and Simulation of Copper Removal from the Contaminated Soil by a Combination of Adsorption and Electro-kinetic Remediation

Volume 19, Issue 6, June 2013, Pages 695-716
Ayad Abed Al-hamza Faisal; Ahmed Alaa Hussein
9.

NEW CONSTRUCTION OF PNEUMATIC RESIDENTIAL ELEVATOR SYSTEM

Volume 17, Issue 2, June 2017, Pages 279-290
Athraa Sabeeh Hasan; Hatam Kareem Kadhim; Jamal Abdul-Kareem Mohammed
10.

Optimization of Surface Roughness for Al-alloy in Electro-chemical Machining (ECM) using Taguchi Method

Volume 23, Issue 10, October 2017, Pages 62-71
Safaa Kadhim Ghazi; Shukry Hammed Aghdeab; Mostafa Adel Abdullah
11.

PERFORMANCE EVALUATION OF ELECTRO-COAGULATION SYSTEM FOR WASTEWATER TREATMENT

Volume 21, Issue 5, October 2017, Pages 101-115
Sadiq S. Muhsun; Mohammed Ibrahem. Basheer; Mohanad M. Mahdi
12.

Pressure Control of Electro-Hydraulic Servovalve and Transmission Line Effect

Volume 9, Issue 3, September 2013, Pages 80-99
Ahmed Fouad Mahdi; Majid Ahmed Oleiwi; Yiqin Xue; Jafar Mehdi Hassan
13.

Recovery of Aluminum from Industrial Waste (Slag) by Melting and Electrorefining Processes

Volume 14, Issue 3, December 2018, Pages 81-91
Maytham Mahmood Ali; Rabiha Saleh Yassen
14.

Technological route and characteristics of home - built Ag, Ag/Cu, and Ag/Ni ohmic conductor pastes

Volume 9, Issue 16, December 2011, Pages 13-17
Mohammed. K. Khalaf; Q. G. Hial; R. J. Sakit
15.

The Electro-Excitation Form Factors of 7Li Nucleus with Exact Center of Mass Correction

Volume 8, Issue 13, December 2010, Pages 38-44
B. S. Al-qazaz; Z. A. Dakhil
16.

The Linear and Nonlinear Electro-MechanicalFin Actuator

Volume 7, Issue 4, December 2011, Pages 88-96
Zeina A. Abdul Redha; Shaimaa A. Mahdi
17.

Thermo-Optic Effects and Opto-Electrical Bias in an Electro-Optic Modulation System

Volume 34, Issue 2, June 2008, Pages 1-7
M. A. Rahma; M. Aillerie; N. Th; H. L. Saadon; ofanous
18.

USE OF CLEAN ENERGY TO REMEDIATE CONTAMINATED SOIL

Volume 22, Issue 1, December 2018, Pages 12-24
Ahmed Alaa Hussein
19.

Utilizing Electro-Hydraulic Actuators in Motion Control System

Volume 0, Issue 16, January 2018, Pages 324-337
Munaf .F. Badr


Journal Management System. Powered by ejournalplus.com